Clutch Control 3; Handlebar; Front Brake Caliper - Malaguti XTM 50 Workshop Manual

A
- CHASSIS
A
CHAPTER
CLUTCH CONTROL
Detach the clutch cable (F - F.41) and the starter
cable (S - F.41) and remove the mirror (A - F.41).
Loosen the screws (V2b - F.41), remove the start-
er lever body (L - F.41) and the left hand knob.
Loosen the screws (V2a - F.41) and remove the
left hand control.

HANDLEBAR

(Remove right and left controls)
•
Loosen the screws (V4 - F.42), to remove the U-
bolts holding the handlebar in place.
Caution!!! When refitting, remember
to tighten the front screws first.

FRONT BRAKE CALIPER

Loosen the screws (V2 - F.43) and disconnect the
pipe (T - F.43), after loosening the hydraulic trans-
mission screw (V - F.43).
Caution!!! When refitting, remember to
replace the copper gaskets and bleed
using the relevant equipment.
34
PAGE
SECTION 2
CHASSIS
Disassembly XTM - XSM
F
S
V
V
4
SECTION 3
A
V
2a
L
2b
F.41
F.42
V
2
T
V
F.43
02.04
ISSUE