Installation Of The Outdoor Unit; Installation On A Concrete Slab; Installation On The Wall - Electra DNC series Service Manual

INSTALLATION MANUAL
6.

Installation of the outdoor unit

The outdoor unit must be installed on a raised and leveled concrete slab, or on a metal rack, with a
height above ground of 100 mm.
Note:
Make sure slotted rubber pads are installed under the outdoor unit supports, otherwise vibrations
might occur, and might be transmitted, with noise, into the building.
6.1

Installation on a concrete slab

6.2

Installation on the wall

•
Anchor the rack to the wall by means of 1/2" diameter bolt - on studs with washers on the
wall's inner side.
•
Make sure that the rack is level.
•
Use only racks that were hot galvanized and are of appropriate strength, to carry the unit's
weight - according to the Israeli standard, part 4.
•
Position the outdoor unit on ribbed rubber pads supplied with the unit.
Fig. 16. Installing the outdoor unit on a concrete slab
Fig. 17. Installing the outdoor unit on a rack frame
English 16
CONTENT
1. Outside the building
2. Outdoor unit
3. Rubber padding under legs
4. Floor
5. Concrete slab
6. Anchoring screws
7. Building