Hanging The Indoor Unit - Electra DNC series Service Manual

INSTALLATION MANUAL
4.1

Hanging the indoor unit

There are two options to hang the indoor unit:
A. By means of a mounting plate.
B. By means of mounting brackets.
4.1.1. Hanging the indoor unit by means of a mounting plate
A. Select the location for the indoor unit while adhering to the instructions provided in
paragraph 3.3.
B. Install two hanging tracks on the unit by means of 3 screws each one (see Fig. 6).
C. Mark the location for anchors on the ceiling.
D. Drill holes for the anchors.
E. Install the mounting plate on the ceiling and tighten the anchors.
F. Raise the unit and slide it onto the mounting plate (see Fig. 6).
Note:
One must level the unit.
Note:
Hanging the indoor unit on a mounting plate enables moving the unit in order to access tubing
connections via the opening of return air panel (while servicing the unit). This option is useful when
the ceilings cannot be taken apart (such as cement board ceilings, etc.). In order to facilitate
moving the unit, the gas tubing must be prepared in an "S" form (see Fig. 7).
Fig. 6. Hanging the indoor unit on a mounting plate
English 9
CONTENT