Yamaha FZ6-SS 2004 Service Manual page 416

YES
This circuit is OK.
EAS00799
3. The turn signal light, turn signal indicator
light or both fail to blink.
1. Turn signal indicator light (LEDs)
S Check the turn signal indicator light for conti-
nuity.
Refer to "CHECKING THE LEDs".
S Are the turn signal indicator light OK?
YES
2. Turn signal switch
S Check the turn signal switch for continuity.
Refer to "CHECKING THE SWITCHES".
S Is the turn signal switch OK?
YES
3. Voltage
S Connect the pocket tester (DC 20 V) to the
turn signal relay coupler (wire harness side)
as shown.
Negative tester probe ! ground
Positive tester probe ! brown/green 1
NO
The wiring circuit
from the main switch
to the tail/brake light
coupler is faulty and
must be repaired.
NO
Replace the meter
assembly.
NO
Replace the left han-
dlebar switch.
8-38
SIGNALING SYSTEM
S Turn the main switch to "ON".
S Measure the voltage (DC 12 V) on brown/
green 1 at the turn signal relay coupler (wire
harness side).
S Is the voltage within specification?
YES
4. Voltage
S Connect the pocket tester (DC 20 V) to the
turn signal relay coupler (wire harness side)
as shown.
Positive tester probe ! ground
Negative tester probe ! brown/white 1
S Turn the main switch to "ON".
S Measure the voltage (DC 12 V) on
1
brown/white
pler (wire harness side).
S Is the voltage within specification?
YES
5. Voltage
S Connect the pocket tester (DC 20 V) to the
turn signal light connector or meter assem-
bly coupler (wire harness side) as shown.
Left turn signal light
A
Right turn signal light
B
Turn signal indicator light
C
ELEC
NO
The wiring circuit
from the main switch
to the turn signal
relay coupler is faulty
and must be re-
paired.
at the turn signal relay cou-
NO
The turn signal relay
is faulty and must be
replaced.