Yamaha FZ6-SS 2004 Service Manual page 303

CONNECTING RODS AND PISTONS
5-78
e. Tighten the nut further to reach the specified
angle (150_).
WARNING
When the nut is tightened more than the spe-
cified angle, do not loosen the bolt and then
retighten it.
Replace the bolt with a new one and perform
the procedure again.
CAUTION:
S Do not use a torque wrench to tighten the
nut to the specified angle.
S Tighten the nut until it is at the specified
angles.
NOTE:
When using a hexagonal nut, note that the
angle from one corner to another is 60_.
ENG