Checking The Pull Lever Shaft And Pull Rod; Installing The Clutch - Yamaha FZ6-SS 2004 Service Manual

CLUTCH
EAS00287
CHECKING THE PULL LEVER SHAFT AND
PULL ROD
1. Check:
S pull lever shaft pinion gear teeth a
S pull rod teeth b
Damage/wear ! Replace the pull rod and
pull lever shaft pinion gear as a set.
2. Check:
S pull rod bearing
Damage/wear ! Replace.
EAS00299

INSTALLING THE CLUTCH

1. Install:
S thrust plate 1
S clutch boss 2
S lock washer 3
S clutch boss nut 4
NOTE:
While holding the clutch boss 2 with the clutch
holding tool 5 , tighten the clutch boss nut.
Universal clutch holder
90890-04089, YM-91042
3. Bend the lock washer tab along a flat side of
the nut.
4. Lubricate:
S friction plates
S clutch plates
(with the recommended lubricant)
Recommended lubricant
Engine oil
5-52
ENG
New
90 Nm (9.0 mSkg, 65 ftSlb)