FRONT AND REAR BRAKES
EAS00582
REPLACING THE FRONT BRAKE PADS
The following procedure applies to both brake
calipers.
NOTE:
When replacing the brake pads, it is not neces-
sary to disconnect the brake hose or disas-
semble the brake caliper.
1. Remove:
S brake hose holder 1
S brake caliper 2
2. Remove:
S brake pads 1
(along with the brake pad shims)
S brake pad shims
(onto the brake pads)
S brake pad spring
3. Measure:
S brake pad wear limit a
Out of specification ! Replace the brake
pads as a set.
4. Install:
S brake pad spring
S brake pad shims
(onto the brake pads)
S brake pads
NOTE:
Always install new brake pads, brake pad
shims, and a brake pad spring as a set.
4-19
CHAS
Brake pad wear limit
0.8 mm (0.03 in)