Yamaha FZ6-SS 2004 Service Manual page 302

CONNECTING RODS AND PISTONS
5-77
6. Install:
S big end bearings
S connecting rod assembly
(into the cylinder and onto the crankshaft pin)
S connecting rod cap
(onto the connecting rod)
NOTE:
S Align the projections on the big end bearings
with the notches in the connecting rods and
connecting rod caps.
S Be sure to reinstall each big end bearing in its
original place.
S While compressing the piston rings with one
hand, install the connecting rod assembly into
the cylinder with the other hand.
S Make sure that the "Y" marks a on the con-
necting rods face towards the left side of the
crankshaft.
S Make sure that the characters b on both the
connecting rod and connecting rod cap are
aligned.
7. Align:
S bolt heads
(with the connecting rod caps)
8. Tighten:
S connecting rod nuts
15 Nm (1.5 mSkg, 11 ftSlb) + 150_
a. Replace the connecting rod bolts and nuts
with new ones.
CAUTION:
Tighten the connecting rod bolts using the
plastic-region tightening angle method.
Always install new bolts and nuts.
b. Clean the connecting rod bolts.
c. Tighten the connecting rod bolts.
d. Put a mark 1 on the corner of the connecting
rod nut 2 and the connecting rod 3 .
ENG