Data Transfer - Miele PW 6321 Operating And Installation Instructions

Control keys
^ Press once to activate the function, press
again to deactivate the function.
i Manual operation
(Used by Miele Service Technicians)
See Programming Manual.
FC Functions
Press this key to temporarily select another
language and/or access the Supervisor
level.
A Back to the previous display
+ i Block plus
The respective program block (e.g.
prewash) will be added to the program.
m Starch Stop
Press this button to stop the program and
allow starch to be added to the laundry.
k Spin Stop
Press this button if a final spin is not required
after the final rinse.
m Delay start
Press this key to select a start time in the
display.
K
Information
To show program information
f Stop/Finish
Press to stop a selected program or end an
already stopped program.
q Drain
ü Skip
Cycles of a program in progress can be
skipped or repeated.
Guide to the washer
e/- Following or previous line
S Save
See Programming Manual
$ Program locked
If a program is locked it cannot be stopped
or ended with the 0 "Off" button after 1
minute.
) Program unlocked
ß Dispensing
ä Dispensing not available
\ Operating data
-> l <- Reset to 0 (zero)
To reset the load sensor to "00.0" when the
drum is empty and the display shows a load
size.
D Data transfer
Operator Card
No programs are saved on this card. To
transfer the data from the control to the card
and vice versa see Programming Manual.
30 programs containing 6 blocks each can
be saved on the card.
The rear side of the card can be labeled.
9