Data Transfer (Optional) - Miele G 7893 Operating Instructions Manual

Data transfer (optional)

This washer-disinfector is fitted with a
interface connector for transferring data
to a report printer.
Printer cables are available from the
Miele Spare Parts department.
The serial interface is RS 232
compatible.
Various printers with Epson compatible
fonts can be used as external printers.
Contact the Miele Service Department
for a list of suitable printers.
Pin configuration in the 9-pole sub-D
connector:
5 GND (base)
3 TXD (transmit)
1-4-6 (linked)
7-8 (CTS)
In accordance with IEC 60950 only
use an industry-standard printer
(e.g. in Germany TÜV, or VDE
approved).
,
The printer must be installed and
set up by a Miele approved service
technician.
44
A report is produced during the
programme sequence. This can be
printed out on an external printer.
It will contain the following data:
– Date and machine number
– Programme start and programme
name
– Blocks used in the programme
– Dispensing system with dosage
temperature and where appropriate
dosage concentration
– Target values for temperature and
temperature holding times
– Minimum temperature during the
temperature holding time
– All faults (e.g. Water inlet fault)
– Programme end
– Fault indications, e.g. insufficient salt