Trane UniTrane Installation, Operation And Maintenance Instructions page 120

Diagnostics
Battery Installation
Prevent Injury!
Batteries can explode or leak and cause burns if installed backwards, disassembled, charged, or
exposed to water, fire, or high temperature.
Prevent Injury!
Keep away from small children. If swallowed, contact your local poison control center
immediately.
6. Observe the polarity indicators that are molded into the cover.
7. Install two batteries (of the type specified in
The sensor has been designed to prevent damage if the batteries are installed backwards, to reduce
the potential for injury.
Manual Association
Before attempting manual or automatic association, the receiver must indicate readiness to
associate (one blink pattern of LED3 on receiver). Refer to
to Associate, " p.
At any time, the manual association method can be used to associate the receiver with the sensor.
If an association was previously established between a receiver and a sensor and needs to be re-
established, the manual association process may be used. If an association has not yet been
established, the automatic association process is recommended (see
the Receiver, " p.
8. Using a small screwdriver, set the three rotary address switches
Notes:
9. Set the three rotary address switches
10. Record the address and location of the receiver and sensor pair.
Disassociation
The receiver disassociates from the sensor (by removing all stored association information),
conducts a channel scan, and restarts itself, if any of the following are true:
•
•
•
•
Note: A disassociated sensor will transit an association request every 10 minutes.
120
WARNING
WARNING
that is molded into the sensor cover.
69.
70).
S2, S3) on the receiver to an address between 001 and 999.
• An address can be changed without powering down the receiver or sensor.
• An address can be changed at any time after initial association has been established.
the same address as the receiver.
• After verifying that the receiver and sensor are powered up, press the Test button on the
sensor to establish that the signal strength
life "Testing Battery Status, " p.
The receiver address is changed from its current setting (001–999)
The receiver receives a disassociation notification from its associated sensor
The receiver does not receive a communication from its associated sensor within 50 minutes.
The sensor and receiver are associated and communicating at the time the sensor is set to 000
and the Test button is pressed.
"Battery Type, " p.
"Observing the Receiver for Readiness
(Figure 19, p. 69, locations S1, S2, S3) on the sensor to
("Testing Signal Strength, " p.
118) are adequate for proper functioning.
119) in the battery-holding slot
"Associating the Sensor to
(Figure 19, p. 69, locations S1,
117) and the battery
UNT-SVX07B-EN