Checking And Servicing The Primary Driving Gear; Disassembling The Primary Driving Gear; Assembling The Primary Driving Gear - Cagiva Navigator Workshop Manual

CHECKING THE PRIMARY DRIVING GEAR/NO.
1 VALVE MOTION SPROCKET AND THE PRI-
MARY DRIVING GEAR/NO. 1 VALVE MOTION
IDLER GEAR/SPROCKET SHAFT
CHECK
Visually check the wear of the gear and sprocket teeth. If the teeth
are worn, replace the gear and the sprocket with new parts.
CHECKING AND SERVICING THE PRIMARY
DRIVING GEAR
CHECKING THE PRIMARY DRIVING GEAR
Visually check the wear of the gear teeth. If the teeth are worn, re-
place the gear.

DISASSEMBLING THE PRIMARY DRIVING GEAR

• Remove the circlip and disassemble the primary driving gear.
Specific tool: 800096765: Snap ring pliers

ASSEMBLING THE PRIMARY DRIVING GEAR

• Fit the springs between the gears as shown in the figure.
• Fully insert gear 1 while turning it clockwise.
D.132
ENGINE
1