Removing The Starting Torque Limiter, The Generator And The Crankshaft Position Sensor - Cagiva Navigator Workshop Manual

REMOVING THE STARTING TORQUE LIMITER,
THE GENERATOR AND THE CRANKSHAFT
POSITION SENSOR
The following components must be removed in the order indicated
so that the starter torque limiter, the generator and the crankshaft
position sensor can be removed.
• This operation can be carried out without removing the engine.
Refer to the pages indicated for details on how to perform each step.
After draining the engine oil:
• Remove the sump guard (see page B-7)
• Remove the left hand footrest complete with the gearchange lever
assembly (see page D-7)
• Unscrew the two screws as shown in the figure and remove the
silencer protection.
• Remove the pinion cover by unscrewing the three fixing screws.
Be careful of the centring pins.
• The clutch throw-out assembly.
• The clutch cable (see page B-16).
• The generator wire.
• The crankshaft position sensor wire.
• The generator cover (see page D-28).
ENGINE
D.135