Yamaha YZF-R1B 2012 Service Manual page 93

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
1. Clutch cable
2. Main switch lead
3. Left handlebar switch lead
4. Steering damper lead
5. Horn lead
6. Horn
7. Brake hose
8. Front brake light switch lead
9. Throttle cable (decelerator cable)
10.Throttle cable (accelerator cable)
11.Right handlebar switch lead
12.Throttle cable
13.Hazard switch
14.Lower bracket
15.Steering damper bracket
16.Front speed sensor lead
17.Steering damper
18.Brake hose holder
A. After passing the clutch cable through the
clutch cable guide, route it along and front
of the main switch.
B. Make sure the main switch lead is not tight
when turning the handle to the right of the
stopper.
C. Route the clutch switch lead outside of the
left handlebar switch lead.
D. Fasten the brake hose at a position actual
measurement of 50 mm (1.97 in) away
from the brake hose clasp, and the front
speed sensor lead on the white tape.
E. 50 mm (1.97 in)
F. Route the front brake light switch lead
under the brake hose.
G. Route the right handlebar switch lead
above the metal fitting on the brake hose.
H. Route the throttle cable above the lower
bracket, inside of the front fork and under
the brake fluid reservoir hose. Throttle
cable (accelerator cable) and throttle cable
(decelerator cable) should not be twisted
together.
I. Fasten the horn lead back and inside of the
steering damper bracket projection.
J. Steering damper bracket projection
K. Face the end of the plastic locking tie to the
left and cut off the excess end leaving 2–4
mm (0.08–0.16 in).
L. Outside of the vehicle.
M. Inside of the vehicle.
N. Fasten the front speed sensor lead within
the area (90°) indicated by the arrows
shown in the illustration.
O. Fasten the front speed sensor lead behind
the brake hose.
email: info@motomatrix.co.uk
P. Fasten the front wheel sensor lead on the
white tape. Face the end of the plastic
band to rear and to inside of the vehicle,
and cut off the excess end leaving 5–10
mm (0.20–0.39 in).
Q. Fasten the front speed sensor lead on the
white tape either in front of or beside the
steering damper motor. Face the end of the
plastic locking tie to outside of the vehicle
and cut off the excess end leaving 2–4 mm
(0.08–0.16 in).
R. Fasten the brake hose with the brake hose
holder.
S. Right side.
T. Left side.
U. Fasten the brake hose and front speed
sensor lead with the brake hose holder.
2-52
CABLE ROUTING