Yamaha YZF-R1B 2012 Service Manual page 22

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
Clock and stopwatch modes
1. Clock/stopwatch
To set the clock
1. Push the "SELECT" button and "RESET"
button together for at least two seconds.
2. When the hour digits start flashing, push
the "RESET" button to set the hours.
3. Push the "SELECT" button, and the minute
digits start flashing.
4. Push the "RESET" button to set the min-
utes.
5. Push the "SELECT" button and then
release it to start the clock.
To display the stopwatch
To change the display to the stopwatch mode,
push the "SELECT" button and "RESET" but-
ton together. To change the display back to the
clock mode, push the "SELECT" button and
"RESET" button together; however, this is not
possible when the stopwatch is counting.
Standard measurement
1. Push the "RESET" button to start the stop-
watch.
2. Push the "SELECT" button to stop the stop-
watch.
3. Push the "SELECT" button again to reset
the stopwatch.
Split time measurement
1. Push the "RESET" button to start the stop-
watch.
2. Push the start switch " " or "RESET" but-
ton to measure split times. Split times are
displayed on the odometer display for five
seconds.
3. Push the start switch " " or "RESET" but-
ton to display the final split time or push the
"SELECT" button to stop the stopwatch and
display the final split time.
email: info@motomatrix.co.uk
Split time history
1. Coolant temperature display/air intake tem-
perature display
2. Stopwatch
The split time history displays up to 20 stored
split times. The split time history can be dis-
played either in reverse chronological order or
by speed.
1. Push the "SELECT" button for at least one
second to select the reverse chronological
order mode; "L20" displays on the stop-
watch.
Push the "SELECT" button again to select
the speed mode; "F20" displays on the
stopwatch.
TIP
• Reverse chronological order mode: The split
times are shown from the latest to earliest
(i.e., L1, L2, L3, L4).
• Speed order mode: The split times are
shown from the fastest to slowest (i.e., F1,
F2, F3, F4).
2. Push the "RESET" button. Depending on
the selected split time, "L1" or "F1" displays
on the coolant temperature display/air
intake temperature display, and its corre-
sponding stored split time displays on the
stopwatch.
3. Push the "SELECT" button to switch the
displayed split time in ascending order (i.e.,
1, 2, 3, 4), and the "RESET" button to
switch the displayed split time in descend-
ing order (i.e., 20, 19, 18, 17).
TIP
• To switch between the reverse chronological
order mode and the speed mode, push the
"SELECT" button for at least one second to
cancel the currently selected mode, and then
repeat step 1 to select the desired mode.
1-13
FEATURES