Yamaha YZF-R1B 2012 Service Manual page 218

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
4. Install:
• Throttle grip
• Throttle cable housing "1"
• Throttle cables
TIP
Align the projection "a" on the throttle cable
housing with the hole "b" in the right handlebar.
5. Install:
• Clutch lever holder "1"
Clutch lever holder bolt
11 Nm (1.1 m·kgf, 8.0 ft·lbf)
TIP
Align the slit on the clutch lever holder with the
punch mark "a" on the left handlebar.
email: info@motomatrix.co.uk
6. Install:
• Left handlebar switch "1"
TIP
• Align the projection "a" on the left handlebar
switch with the hole "b" on the left handlebar.
• There should be 2.0–2.5 mm (0.08–0.10 in)
of clearance between left handlebar switch
and clutch lever holder.
7. Install:
• Handlebar grip
• Grip end
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Apply a thin coat of rubber adhesive onto
the end of the left handlebar.
b. Slide the handlebar grip over the end of the
left handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
EWA14B1007
WARNING
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
TIP
When installing the handlebar grip, keep the
clearance of 1.0–3.0 mm (0.04–0.12 in)
between the handlebar grip and grip end.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
8. Adjust:
• Clutch cable free play
Refer to "ADJUSTING THE CLUTCH
CABLE FREE PLAY" on page 3-14.
Clutch lever free play
10.0–15.0 mm (0.39–0.59 in)
4-59
HANDLEBARS