Yamaha YZF-R1B 2012 Service Manual page 91

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
1. Meter assembly
2. Meter lead
3. Meter bracket
4. Right auxiliary light lead
5. Headlight sub-wire harness
6. Headlight lead
7. Intake air temperature sensor
8. Left auxiliary light lead
9. Right air intake air duct cover
10.Right front intake air duct
11.Turn signal relay
12.Headlight relay
13.Left front intake air duct
14.Left air intake air duct cover
15.Wire harness holder
16.Headlight assembly
A. Make sure to insert the coupler and boots
into the meter. Edge of the boots should
not turn inward/outward.
B. The meter lead should not protrude out.
C. To the meter assembly
D. Route the auxiliary light lead under the
front intake air duct and connect.
E. To the main harness
F. To the turn signal
G. Avoid the purple tape when fastening the
headlight sub-wire harness. When fasten-
ing the headlight sub-wire harness, it
should not be sagged. Face the end of the
clamp to front.
H. Route the headlight lead toward the front of
the meter bracket and connect.
I. The auxiliary light lead should not be
pinched when installing the air intake air
duct cover, and should be placed within the
air intake air duct cover.
J. Secure the turn signal relay by inserting it
all the way in to the headlight right rib.
K. The turn signal relay and headlight relay
can be installed either right/left.
L. Secure the headlight relay by inserting it all
the way in to the headlight left rib.
M. Fasten the wire harness holder along the
guide line on the front cowling with the wire
harness holder opening facing rear of the
vehicle.
N. Fasten the wire harness so that the notch
faces rear of the vehicle (The wire harness
should be directed as shown in the illustra-
tion).
O. Cut off the end of the clamp.
email: info@motomatrix.co.uk
2-50
CABLE ROUTING