Yamaha YZF-R1B 2012 Service Manual page 530

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
6. Install:
• Battery seat
• Battery
7. Connect:
• Battery leads
(to the battery terminals)
ECA13630
First, connect the battery positive lead "1",
and then the battery negative lead "2".
TIP
Set the battery seat end "a" proper position.
8. Check:
• Battery terminals
Dirt → Clean with a wire brush.
Loose connection → Connect properly.
9. Lubricate:
• Battery terminals
Recommended lubricant
Dielectric grease
10. Install:
• Battery cover
• Rider seat
Refer to "GENERAL CHASSIS" on page
4-1.
EAS28040
CHECKING THE RELAYS
Check each switch for continuity with the
pocket tester. If the continuity reading is incor-
rect, replace the relay.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
1. Disconnect the relay from the wire harness.
email: info@motomatrix.co.uk
ELECTRICAL COMPONENTS
2. Connect the pocket tester (Ω × 1) and bat-
tery (12 V) to the relay terminal as shown.
Check the relay operation.
Out of specification → Replace.
Starter relay
1. Positive battery terminal
2. Negative battery terminal
3. Positive tester probe
4. Negative tester probe
Result
Continuity
(between "3" and "4")
Relay unit (starting circuit cut-off relay)
1. Positive battery terminal
2. Negative battery terminal
3. Positive tester probe
4. Negative tester probe
Result
Continuity
(between "3" and "4")
8-133