Gas Supply Electrical Supply - elco VECTRON G 05.700 MODULO Operating Instructions Manual

Table of Contents

Advertisement

Assembly
Gas supply
Electrical supply
General regulations for the gas supply
· Connection of the gas valve
assembly to the gas mains must be
carried out by a recognised
specialist.
· The cross-section of the gas cable
must be such that the prescribed
gas flow pressure at the gas valve
inlet is not undershot.
Burner start-up automatically implies
acceptance of the system. This is the
responsibility of the installer or his
representative as he alone can
guarantee that the system conforms to
the current standards and regulations.
Electrical supply to the burner
For connection of the burner and
regulator, the corresponding circuit
diagram is mandatory.
The power supply and the electrical
connections must comply with the
applicable standards.
The installer must hold a licence issued
by the gas authority, must have
checked the system for leaks and must
have vented it.
m
N.B.:
· Before connecting the burner to the
electrical supply, close the gas
ball valve.
· Set the main switch of the burner
control panel to zero.
Before any intervention on the
connector of the gas and air servomo-
tors, the display or the e-Bus connec-
tion, the burner must be switched off by
disconnecting the 7-pin plug.
Burner and regulation connection
Insert the 4-pin and 7-pin plug of the
boiler control panel in the correspond-
ing sockets of the burner.
Gas valve connection
· Connect the gas valve to the plugs
located on the burner (black to
black, grey to grey).
· Insert connector 1 between burner
and gas throttle servomotor in
accordance with the diagram below.
09/2005 - Art. Nr. 13 019 526A
Burner motor connection
The burner is delivered with a neutral
wire and earthing for a mains voltage of
400V-50Hz AC.
The connection cable for the burner
motor must be run through the cable
fittings and wired to the terminal strip as
indicated in the electrical diagram.
Check the direction of rotation of the
fan motor (see arrow on burner casing)
via manual activation of the burner
protection device.
EN
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vectron g 05.1000 modulo

Table of Contents