SunStar SPS/B-1811 SERIES User Manual page 7

1-4)Machine
Operation
Warning
1-5)Devices for
Safety
Notice
SPS/B(A)-1811(2211) Series are made for industrial use to perform pattern sewing
for fabrics or its similar materials. Please observe the following principles.
ⓐ Read the manual to understand on the operation of machine perfectly.
ⓑ Wear suitable clothes and cap for safe operation.
ⓒ During operation, don' t make you body close to operating part of machine such
as needle, hook, take-up lever or pulley.
ⓓ Do not remove a safety plate and covers during operation
ⓔ Be sure the grounding lines in connected.
ⓕ Before opening electricity box such as control box, cut off the supply of
electricity and confirm if the switch is "off" .
ⓖ When inserting thread into a needle or before inspecting after sewing, be sure
the machine is stopped.
ⓗ Do not turn on the power during pedaling.
ⓘ Do not use several motor per a electric outlet.
ⓙ Install the machine apart from noise occurrence area such as high frequency
welding machines as far as possible.
ⓚ Be careful-When the upper feed plate comes down to press. Otherwise, the
finger or hand hight be hurt at smacking.
[ Warning ]
Belt will crush or amputate finger or hand, keep cover in place before
operating, turn off power before inspecting or adjusting.
ⓐ Safety label : It describes cautions during operating the machine.
ⓑ Thread take-up lever : It prevents from any contact between body and take-up
lever.
ⓒ Servo motor cover : It prevents from insertion of hands, feet or clothes by motor
and Y-drive shaft.
ⓓ Step motor cover : It prevents from accidents during rotation of step motors.
ⓔ Label for specification of power : It describes cautions for safety to protect
against electric shock during rotating the motors.
ⓕ Safety plate : It protects eyes against needle breaks.
ⓖ Finger guard : It prevent from contacts between a finger and needle.
ⓕ
ⓖ
ⓑ ⓐ
ⓒ
ⓓ
ⓐ
ⓔ
7