Hitachi Compute Blade 500 Series System Overview Manual page 24

Location
4
5
6
7
8
9
1-16
Name
Power switch with Power LED -
Location Identify LED (LID)
Attention LED (ATN)
Alarm LED (ALM)
Expansion LED
Diagnostic LED
System Overview
Hitachi Compute Blade 500 Series System Overview Guide
State
Green-On
Green-Blink
Blue-On
Amber-On
Amber-On
Amber-On
LP Green-On
SYS BRD Amber-On
NMI Amber-On
SEE EXP Amber-On
Description
Connect a KVM cable to
1
this port.
Press this switch to power-
on.
Press and hold this switch
for four seconds or more to
force the main power-off.
Main power of the server
blade is turned on.
Main power of the server
blade is turned off.
Slow blink: The server
blade is ready to be turned
on.
Rapid blink: The server
blade is initializing.
Identifies the server blade.
Configuration mismatch
errors other than failures
are detected in the server
blade, such as the installed
Mezzanine card does not
correspond to or does not
support the switch module.
Indicates explicitly that the
power button with LED was
pressed. The LED is turned
on when you press the
power button, and then
turned off when the main
3
power is turned on.
Indicates a fault that
requires an HDD to be
exchanged was detected in
the server blade.
Indicates a fault that
requires an expansion
blade to be exchanged was
detected.
The LED panel is active.
The motherboard needs to
be replaced.
A Non-Maskable Interrupt
(NMI) was generated.
Not supported
2