Hitachi Compute Blade 500 Series System Overview Manual page 28

Location
1
2
3
4
5
6
7
8
9
1-20
Table 1-10 Server Blade Switches, Indicators and Connectors
Name
USB
NMI Reset Switch
KVM
Enclosure Power LED with
Integrated Power Switch
Enclosure Identify LED
Error Log LED
Enclosure Fault LED
Primary LED
QPI Link Fault LED (ERR)
System Overview
Hitachi Compute Blade 500 Series System Overview Guide
State Description
- USB port in the server
blade.
- Press this switch to issue a
Non-Maskable Interrupt
(NMI) of the server blade.
- Provides VGA, serial port
and 2 USB port outputs.
Connect a KVM cable to
this port.
- Press this switch to power-
on.
Press and hold this switch
for four seconds or more to
force the main power-off.
Green-On Main power of the server
blade is turned on.
Green-Blink Main power of the server
blade is turned off.
Slow blink: The server
blade is ready to be turned
on.
Rapid blink: The server
blade is initializing.
Blue-On Identifies the server blade.
Amber-On Configuration mismatch
errors other than failures
are detected in the server
blade, such as the installed
Mezzanine card does not
correspond to or does not
support the switch module.
Indicates explicitly that the
power button with LED was
pressed. The LED is turned
on when you press the
power button, and then
turned off when the main
power is turned on.
Amber-On Indicates a fault that
requires an HDD to be
exchanged was detected in
the server blade.
White-On Indicates this is the
primary server blade.
Amber-On An error occurred in QPI
link in SMP configuration.
1
2
3