Adjusting The Feed Amount - Canon iPF6400S Basic Manual

Adjusting the feed amount

Selecting a Feed Amount Adjustment Method ............................................................................................... 99
Automatic Banding Adjustment .................................................................................................................... 100
Selecting a Feed Amount Adjustment Method
There are two methods of adjusting the paper feed amount, Print Quality and Print Length, either of
which will be applied during printing.
Since the method that is applied during printing is determined from the value of the Adj. Priority
setting, configure the Adj. Priority to match the print target.
• Print Quality : Adjusts the feed amount to reduce banding across the sheet in printed documents.
Adj. Quality settings are applied. When Adj. Fine Feed is executed, the Adj. Fine Feed settings
are applied in addition to the Adj. Quality settings.
• Print Length : Adjusts the feed amount for better accuracy of lines in printed documents.
The settings of A:High or B:Standard/Draft in Adjust Length are applied.
• Automatic: Print Quality or Print Length is selected, depending on Print Priority as selected in
the printer driver at the time of printing.
• Either A:High or B:Standard/Draft in the Adjust Length menu is applied, depending on
printer driver settings at the time of printing.
Note
Follow these steps to configure the settings.
1 Load the paper.
• "Loading Rolls on the Roll Holder"➔P.12
• "Loading Rolls in the Printer"➔P.14
• "Loading Sheets in the Feed Slot"➔P.21
2 On the Tab Selection screen of the Control
Panel, press ◀ or ▶ to select the Settings/Adj.
tab ( ).
• If the Tab Selection screen is not displayed, press the Menu button.
Note
3 Press the OK button.
The Set./Adj. Menu is displayed.
Press ▲ or ▼ to select Adjust Printer, and then press the OK button.
4
iPF6400S Basic Guide
99