Whirlpool WWDC-7444 Instructions For Use Manual page 13

Hide thumbs


on display
(if available)
from "F03" to "F43"
(except "F18" and
"F02" or "FA"
(if available on your
"F18" or "Fod"
If any of the faults described above persist, unplug the appliance, turn off the water tap
and contact our After-Sales Service (see next chapter).
"Electrical module fault"
Push the "Reset" button for at least 3 seconds.
May appear for very water-soaking laundry, or if you added
too much laundry for a programme destined for small loads
only. Do not overload the washing machine.
Push the "Reset" button for at least 3 seconds to stop the
programme. Select and start "Rinse and Spin" programme to
complete the interrupted wash programme properly.
"Waterstop fault"
Turn the programme selector to the "Off/O" position, pull out
the mains plug and turn the water tap off. Tilt the appliance
forward carefully (a second person must help you) to allow
light up)
collected water to flow out from the bottom. Then:
• Plug in the appliance again.
• Turn the water tap on (if water immediately flows into the
appliance without the appliance being started, there is a
failure; turn off the tap and notify the After-Sales Service).
• Select and start the desired programme again.
Too much foam interrupted the wash programme. If your
washing machine has a "Dosing Aid" function, and you used it:
check if the dosing values set for the different programme
groups correspond to the dosing values recommended for the
detergents you use (see details in separate Instructions for the
"Dosing Aid").
• Select and start the "Rinse & Spin" programme.
• Afterwards select and start the desired programme again,
using less detergent. See also description of problem "The
machine is at a standstill...." in the previous part of the
Troubleshooting Guide.
EN 12

Hide quick links:



  Related Manuals for Whirlpool WWDC-7444

This manual is also suitable for:

Awoe 11149Wwdc 9400

Table of Contents