Operating Procedures - Cushman Turf Truckster 84063 Safety & Operation Manual

5 OPERATION
5.3

OPERATING PROCEDURES_________________________________________________

A Rollover Protection Structure (ROPS) for this utility vehicle is included as standard equipment. Seat belts must be
worn whenever a ROPS is installed on the vehicle. Always keep seat belt snugly adjusted. DO NOT use seat belts
on a utility vehicle without a ROPS.
If a ROPS is installed and the vehicle is overturning, hold onto the steering wheel. Do not attempt to jump out or
leave the seat.
To prevent injury, always wear safety glasses, leather work shoes or boots, a hard hat, and ear protection. Wear
any protective equipment recommended by the chemical manufacturer.
1. Under no circumstances should the engine be
started without the operator seated on the utility
vehicle.
2. Do not operate utility vehicle or attachments with
loose, damaged, or missing components. Whenever
possible operate when grass is dry.
3. Never remove or install the engine cover while the
engine is running. The engine cover is a machinery
guard and its removal exposes you to moving parts.
Keep hands, hair, and clothing away from flywheel,
radiator cooling fan, alternator fan, engine belts,
pulleys, and air intake.
!
WARNING
Failure to latch the engine cover properly can result in
the engine cover tipping forward causing loss of
control of the vehicle and possible personal injury.
4. Study the area to determine the best and safest
operating procedure. Consider the type of terrain,
and condition of the surface. Each condition will
require certain adjustments or precautions.
5. Never direct discharge
bystanders, nor allow anyone near the machine
while in operation.
responsible for injuries inflicted to bystanders and/or
damage to their property.
!
CAUTION
Before operating, pick up all debris such as rocks,
toys, and wire which can be thrown by the machine.
Enter a new area cautiously. Always operate at
speeds that allow you to have complete control of the
utility vehicle.
en-18
!
WARNING
!
CAUTION
of material toward
The owner/operator
6. Always disengage hydraulic system when not in
use.
7. Slow down and look in both directions when
crossing paths or roadways. Look out for traffic.
8. Stop and inspect the equipment for damage
immediately after striking an obstruction or if the
machine begins to vibrate abnormally. Have the
equipment repaired before resuming operation.
Before you
equipment, always disengage hydraulic system,
engage parking brake, stop engine, and remove
key from ignition switch to prevent injuries.
9. Slow down and use extra care on hillsides. Read
Section 5.12. Use caution when operating near drop
offs.
10. Look behind and down before backing up to be sure
the path is clear. Use care when approaching blind
corners, shrubs, trees, or other objects that may
obscure vision.
11. Use care when pulling loads or using heavy
equipment. Use only approved drawbar hitch points
is
and limit loads to those you can safely control. Do
not turn sharply. Use care when reversing. Use
counterweights or wheel weights as suggested in
accessory manuals.
!
WARNING
clean, adjust, or repair this