Panasonic KX-TA616 Installation Manual page 42

2.18
Installing a 3-CO Line & 8 Ext Expansion Card (KX-TA30877)
and 8 SLT Extn. Expansion Card (KX-TA30874)
5. Insert the modular plugs of the telephone line cords (2-conductor wiring) into the
modular jacks (CO 4 through 6) on the card. (
6. Connect the line cords to the terminal board or the modular jacks from the Central Office.
7. Insert the modular plugs of the telephone line cords (2 or 4-conductor wiring) into the
modular jacks (JACK 09 through 16). (
8. Wrap the strap around all of the cords. (
9. Close the covers and secure the screws.
Installing the KX-TA30874
1. Loosen the screws and open the front and bottom front covers.
2. If your system is a KX-TA308, remove the lower front panel in the same way as
installing a KX-TA30877. If you install the KX-TA30874 to a KX-TA616 or a
KX-TA30877, which is connected to a KX-TA308, remove the top front panel with
pliers.
3. After cutting the areas, be sure to cut off any excess plastic in order to make the surface
smooth. Please refer to installing the KX-TA30877.
2-26
Installation
Top front panel
2.7, Outside (CO) Line Connection)
2.8, Extension Connection)
2.20, Securing the Cords)