Gas Connections - ESAB Cutmaster 60 Operating Manual

ESAB CuTmASTEr 60
6. Connect the wires as follows.
• Wiring to L1, L2 and L3 input. See the previ-
ous illustration and power label. It does not
matter what order these wires are attached.
• Green / Yellow wire to Ground.
7. With a little slack in the wires, tighten the
through - hole protector to secure the power
cable.
8. Reinstall the Power Supply cover per instruc-
tions found in Section 5.
9. Connect the opposite end of individual wires to
a customer supplied plug or main disconnect.
10. Connect the input power cable (or close the
main disconnect switch) to supply power.
3.04

Gas Connections

Connecting Gas Supply to Unit
The connection is the same for compressed air or
high pressure cylinders. Refer to the following two
subsections if an optional air line filter is to be installed.
1. Connect the air line to the inlet port. The il-
lustration shows typical fittings as an example.
NOTE!
For a secure seal, apply thread sealant to the fitting
threads, according to manufacturer's instructions.
Do not use Teflon tape as a thread sealer, as small
particles of the tape may break off and block the
small air passages in the torch.
Regulator/Filter
Assembly
Hose Clamp
Gas Supply
Hose
Art # A-07943
Air Connection to Inlet Port
3-2
Installing Optional Single - Stage Air Filter
An optional filter kit is recommended for improved
filtering with compressed air, to keep moisture and
debris out of the torch.
1. Attach the Single - Stage Filter Hose to the
2. Attach the Filter Assembly to the filter hose.
3. Connect the air line to the Filter. The illustra-
Hose Clamp
Gas Supply
Hose
Inlet Port
1/4 NPT or ISO-R
to 1/4" (6mm) Fitting
INSTALLATION
Inlet Port.
tion shows typical fittings as an example.
NOTE!
For a secure seal, apply thread sealant to the fitting
threads, according to manufacturer's instructions.
Do not use Teflon tape as a thread sealer, as small
particles of the tape may break off and block the
small air passages in the torch.
Regulator/Filter
Assembly
Optional Single - Stage Filter Installation
Inlet Port
Art # A-07944
1/4 NPT to 1/4"
(6mm) Fitting
Manual 0-5402