Motorola 9500 User Manual page 65

If you want to...
End Current Call
End Call that is on
Hold
You may see one of these messages:
Message
Trying
Hold
Failed
Cannot Hold
Second Call
Reconnect
Failed
Busy
Try Later
To place a call on hold, you must send a phone
flash (see page 62 for more information) along with
the appropriate feature code provided by your
service provider. To return to your initial call, you
must send another phone flash. To send a phone
flash, see page 62.
This feature is not available in GSM cellular mode.
Then...
C
Press at any time.
M
Press until you will see
Held Call
, and then press
select.
The held call is disconnected, the
current call remains connected,
End Call?
and you see
Description
Your phone is attempting to switch
between the current and held call.
The attempt to hold a call was
unsuccessful.
A call is already on hold. You can
only place one call on hold.
The held call could not be made
active again.
Your phone is working on a
previous command. Wait a short
time before repeating the new
command.
End
O
to
.
Cellular
Mode
(CDMA/
AMPS)
Cellular
Mode
(GSM)
Using In-Call Features 61