DRIVEN CLUTCH SERVICE (LATE BUILD 2009 RZR / ALL 2010 MODELS)
Exploded View
Stationary
Secondary Sheave
Clutch Disassembly / Inspection
CAUTION
Wear eye protection when removing snap ring to
prevent serious personal injury.
Use caution when removing, the snap ring
pressure is loaded by the compression spring.
1.
Remove driven clutch from the transmission input shaft.
2.
Mark the position of the clutch sheaves before disassembly
or use the X's on the sheaves for reference. This aids in
reassembly and maintains clutch balance after reassembly.
Spring Retainer
Moveable
Secondary Sheave
Inner
3.
Place the clutch into the Clutch Compression Tool PN
8700220. Using Compression Extensions PN PS-45909,
apply and hold downward pressure on the outer spring
retainer. Carefully remove the snap ring. Remember the
outer spring retainer contains strong spring pressure.
Remove Snap Ring
Outer Spring Retainer
NOTE: Spring is compression only and has no
torsional wind.
CLUTCHING
Compression Spring
Spacer
Outer
Spring Retainer
Retaining
Ring
6
6.29