Polaris 2010 Ranger RZR 800 EFI Manual page 293

Pivot Pin Set Screw:
100-125 in. lbs. (11-14 Nm)
7. Assemble the clutch shaft with new needle bearings. Press
a new ball bearing onto the end of the shaft and install a new
retaining ring.
8. Install the clutch shaft into the transmission housing.
9. Install the sliding shoes onto the clutch yoke.
= T
10. Install the shift collar onto the clutch shaft. Pull back fully
on gear selector arm to bring the shift yoke arms up and
engage the shift shoes onto the center groove of the shift
collar. Shifting the clutch shaft position may aid in shift
collar installation. Install the park/reverse spacer on top of
the shift collar as shown.
MY09 Shift Collar and
Clutch Shaft Shown
11. Install the dent sleeve assembly, ball, spring and outer
detent screw. Use new O-rings anytime these screws are
removed. Torque the detent sleeve assembly to
specification. TURN THE OUTER DETENT SCREW
ONLY UNTIL LIGHT SHIFTING RESISTANCE IS
FELT AT THIS TIME. PLACE THE TRANSMISSION
IN NEUTRAL.
Detent Sleeve Assembly:
40-45 ft. lbs. (54-61 Nm)
TRANSMISSION
= T
8.15
8