Polaris 2010 Ranger RZR 800 EFI Manual page 295

16. Install the reverse clutch assembly onto the park flange.
Note the orientation of the needle bearing.
17. Install the retaining plate and a new retaining ring.
18. Install the input shaft seal and verify it is fully seated. Install
the intermediate shaft seal (circled) flush or slightly below
the case. Apply lubricant to both seal lips.
19. Place the transmission shift housing onto a flat surface as
shown. Apply a bead of crankcase sealant onto the mating
surfaces. Align the dowels and install the transmission case
half onto the shift housing while rotating the input shaft,
using care not to damage the seal surfaces.
Apply Sealant PN 2871557
to Case Mating Surfaces
20. Install the shift cable bracket (7) shift housing case screws
to the front of the transmission. Torque to specification.
Shift Housing Screws:
23-27 ft. lbs. (31-37 Nm)
TRANSMISSION
2871557
= T
8.17
8