License Key Upgrades; Figure 26: T1/E1 Port Upgrade Window; Figure 27: Key Accepted Window; Procedure 30: Installing A License Key To Enable An Additional Port - Motorola Canopy T1/E1 User Manual

Canopy T1/E1 Multiplexer
3.7 LICENSE KEY UPGRADES
As previously described, you can transform any single-port enabled Canopy T1/E1
Multiplexer into a 2-port, 3-port, or 4-port multiplexer through the purchase and
installation of license keys from your Canopy distributor.

Procedure 30: Installing a license key to enable an additional port

To install a license key on a Canopy T1/E1 Multiplexer, perform the following steps.
1. From the main menu of the EMS, select Config→T1/E1 Port Upgrade
Config→Software Upgrade (shown in
RESULT: The Canopy T1/E1 Port Upgrade window opens, as shown in
Figure
2. Type in the upgrade key that your Canopy distributor provided for this unit, then
press Enter.
3. Click Done.
RESULT: If the upgrade succeeded, then the Key accepted window appears
(see Figure
If the upgrade failed, then the Failed: Invalid key entry window appears (see
Figure
Issue 3
26.

Figure 26: T1/E1 Port Upgrade window

27).
28).

Figure 27: Key accepted window

Page 61 of 73
T1/E1 Multiplexer FPGA Version 3.4
Figure 15 on Page 33).
September 2004