Figure 28: Invalid Key Entry Window; Figure 29: Canopy T1/E1 Mux Configuration Window - Motorola Canopy T1/E1 User Manual

Canopy T1/E1 Multiplexer
NOTE: At any later date, you can confirm the number of enabled ports as follows.
4. From the main menu, select Config→Canopy T1/E1 Mux.
RESULT: The Canopy T1/E1 Mux Configuration window opens, as shown in
Figure

Figure 29: Canopy T1/E1 Mux Configuration window

5. In the lower right quadrant of the window, find the Enabled T1/E1 Ports block.
NOTE: Each enabled port is identified by a black check mark.
Issue 3

Figure 28: Invalid key entry window

29.
end of procedure
Page 62 of 73
T1/E1 Multiplexer FPGA Version 3.4
September 2004