Table of Contents
Advertisement
Canopy T1/E1 Multiplexer
Follow these steps to display the T1/E1 alarms using the EMS.
1. Select the Alarms→T1/E1 Alarms menu.
RESULT: The T1/E1 Alarms window pops up as shown in
2. Select the desired T1/E1 Channel (1 through 4).
NOTES:
1. The T1/E1 alarms will be displayed, with a green light meaning no current alarms
and a red light meaning that there is a current alarm. The alarms are also
displayed in text form: No means that there is not a current alarm. Yes means
that there is a current alarm.
2. The Alarms Log window lists alarms that have occurred for all 4 T1/E1s while the
window is open. An alarm log file is automatically written for all 4 T1/E1s. The
file exits in the same directory in which the T1/E1 Multiplexer EMS exists. The
filename is apt1AlarmsLog.txt. The log file can be written only when the
T1/E1 Multiplexer EMS is running.
Issue 3
Procedure 24: Displaying alarms using the EMS
end of procedure
Figure 21: Canopy T1/E1 Mux Alarms window
Page 55 of 73
T1/E1 Multiplexer FPGA Version 3.4
September 2004
Figure
21.
Advertisement
Table of Contents
