Select Line Type T1 Or E1; Select Line Coding; Procedure 16: Selecting Line Type T1 Or E1 Using The Ems; Procedure 17: Configuring T1 Line Coding Using The Ems - Motorola Canopy T1/E1 User Manual

Motorola switch user guide
Hide thumbs Also See for Canopy T1/E1:
Table of Contents

Advertisement

Canopy  T1/E1 Multiplexer 
 
 
 
2.5.3
Select Line Type T1 or E1 

Procedure 16: Selecting line type T1 or E1 using the EMS

Follow these steps to configure line coding for the Canopy T1/E1 Multiplexer from the
EMS.
NOTE: Selecting either T1 or E1 will configure all 4 channels.
1. From main menu EMS, select the Configuration (Config) option.
2. Select Configure Line Type.
RESULT: The Line Config dialogue box opens.
3. Click ↓.
RESULT: The dropdown list to specify the coding technique T1 channel opens.
4. Click on the appropriate line coding technique for the T1channel being
configured.
5. Click on the tab for the next Channel to configure line coding for channel.
6. To configure the line coding technique for each channel, repeat Steps 3 and 4.
7. When all channels are configured, select the File→Reset menu option.
RESULT: A confirmation window pops up.
8. To reset the system, select Yes.
9. Select Close.
RESULT: The dialogue box closes and you are returned to the EMS main menu.
2.5.4
Select Line Coding 

Procedure 17: Configuring T1 line coding using the EMS

Follow these steps to configure T1 line coding from the EMS.
1. From main menu EMS, select the Configuration (Config) option.
2. Select Configure T1.
RESULT: The Config dialogue box opens.
3. Click ↓.
RESULT: The dropdown list to specify the coding technique T1 channel opens.
4. Click on the appropriate line coding technique for the T1channel being
configured.
NOTE: You must select a coding technique: either B8ZS or AMI.
5. Click on the tab for the next Channel to configure line coding for channel.
NOTE: If the system has been reset, clicking the Refresh button will replace the
displayed values with currently-programmed values.
6. To configure the line coding technique for each other channel, repeat Steps 3
and 4.
7. Select Close to close the dialogue box once all channels are configured.
RESULT: You are returned to the EMS main menu.
 
Issue 3
 
 
 
 
 
end of procedure
end of procedure
Page 49 of 73 
 
 
 
     
      T1/E1 Multiplexer FPGA Version 3.4 
 
September 2004 

Advertisement

Table of Contents
loading

Table of Contents