Canopy T1/E1 Multiplexer
2.4.4
Select Line Coding
Follow this procedure to select the appropriate line code using the CLI manager.
Action
Log in
Set line code
Get line code
Issue 3
Procedure 9: Configuring line coding using the CLI
Press Enter.
At the username prompt, enter admin.
At the password prompt, enter password.
Enter set line [1/2/3/4] code [HDB3/B8ZS/AMI]
where
HDB3 sets the line type to HDB3 for all 4 E1 ports
B8ZS sets the line type to B8ZS for all 4 T1 ports.
AMI sets the line type to AMI for all 4 E1 or T1 ports.
RESULT: The system selects the line code for all four ports, as in the
following example.
Line code [1/2/3/4] set to [HDB3/B8ZS/AMI]
Enter get line code.
RESULT: The system returns the line code for all four ports, as in the
following example.
Line code [1/2/3/4] set to [HDB3/B8ZS/AMI]
end of procedure
Page 38 of 73
T1/E1 Multiplexer FPGA Version 3.4
Steps
September 2004