Configuration Procedures Using The Cli; Logging Into The System; Changing The Administrator Password; Procedure 7: Changing Administrator Password Using The Cli - Motorola Canopy T1/E1 User Manual

Motorola switch user guide
Hide thumbs Also See for Canopy T1/E1:
Table of Contents

Advertisement

Canopy  T1/E1 Multiplexer 
 
 
 
NOTE:
The default administrator account username is admin.
The default administrator account password is 123.
You cannot change the username. However, you can change the
password at any time. If you forget your password, reset the system
back to the default account and password by logging in, using the safety
account.
The safety account username is safety.
The safety account password is SAFE_qwe.
When you log in using this account, the password for the administrator
account is reset to 123.The system will then log you out, at which point
you may log in using the default administrator account username and
password.
2.4 CONFIGURATION PROCEDURES USING THE CLI 
2.4.1
Logging into the System 
To gain access to the CLI, log into the system as described under Configuration
Procedures Using the EMS.
2.4.2
Changing the Administrator Password 

Procedure 7: Changing Administrator password using the CLI

Use this procedure to use the CLI manager to change the Administrator account
password.
1. Press Enter.
2. At the username prompt, enter admin.
3. At the password prompt, enter 123.
4. Enter change password.
5. At the prompt Enter your old password: Password:, enter your old
password.
6. At the prompt Enter your new password: Password:, enter your new
password.
7. At the prompt Enter your new password: Password:, re-enter your new
password.
RESULT: The system responds: Password has been changed.
8. To log off, enter lo.
9. Press Enter.
 
Issue 3
 
 
 
 
 
Page 36 of 73 
 
 
 
     
      T1/E1 Multiplexer FPGA Version 3.4 
 
September 2004 

Advertisement

Table of Contents
loading

Table of Contents