Table of Contents
Advertisement
Canopy T1/E1 Multiplexer
3.3 SYSTEM RESET
Follow the steps below to reset the system from the CLI.
Action
Log in
Reset system
Follow these steps to reset the system using the EMS.
1. Select the File→Reset menu option.
RESULT: A confirmation window pops up.
2. To reset the system, select Yes.
NOTE: Selecting No cancels the action, and the system will not be reset.
Issue 3
Procedure 25: Resetting the system using the CLI
Press Enter.
At the username prompt, enter admin.
At the password prompt, enter password.
Enter reset.
RESULT: The system responds Resetting, then immediately resets
both Ethernet Interfaces and all 4 T1/E1 interfaces without asking for a
confirmation.
end of procedure
Procedure 26: Resetting the system using the EMS
Figure 22: EMS reset confirmation box
end of procedure
Page 56 of 73
T1/E1 Multiplexer FPGA Version 3.4
Steps
September 2004
Advertisement
Table of Contents
