Table of Contents
Advertisement
Canopy T1/E1 Multiplexer
10. At the username prompt, enter admin.
11. At the password prompt, enter your new password.
2.4.3
Select Line Type T1 or E1
Procedure 8: Selecting line type T1 or E1 using the CLI
Follow this procedure to select the appropriate line type using the CLI manager.
Action
Log in
Get line type
Set line type
Reset system
Issue 3
end of procedure
Press Enter.
At the username prompt, enter admin.
At the password prompt, enter password.
Enter get line type.
RESULT: The system returns the line type for all four
ports, as in the following example:
Line type
[T1/E1]
Enter set line type [T1/E1]
where
T1 sets the line type to T1 for all 4 ports.
E1 sets the line type to E1 for all 4 ports.
RESULT: The system acknowledges the new setting for
line type for all four ports, as in the following example:
Line type [T1/E1]
Enter reset.
RESULT: The system responds Resetting, then
immediately resets both Ethernet Interfaces and all 4
T1/E1 interfaces without asking for a confirmation.
CAUTION!
The previously configured line type
remains in effect until the system is
reset. Therefore, this step should
always be followed by a reset.
end of procedure
Page 37 of 73
T1/E1 Multiplexer FPGA Version 3.4
Steps
September 2004
Advertisement
Table of Contents
