Canopy T1/E1 Multiplexer
2.4.4
Select Line Coding
Follow this procedure to select the appropriate line code using the CLI manager.
Action
Log in
Set line code
Get line code
2.4.5
Configure Ports
Procedure 10: Configuring the Ethernet ports using the CLI
Perform this procedure to configure the Ethernet ports using the CLI manager.
NOTE: Both Ethernet ports operate at 100 Mbps Full Duplex. They will not operate at
10 Mbps or at half duplex.
Action
Log in
Set BH-side Ethernet auto-
negotiation
Issue 1
Procedure 9: Configuring line coding using the CLI
Press Enter.
At the username prompt, enter admin.
At the password prompt, enter password.
Enter set line [1/2/3/4] code [HDB3/B8ZS/AMI]
where
HDB3 sets the line type to HDB3 for all 4 E1 ports
B8ZS sets the line type to B8ZS for all 4 T1 ports.
AMI sets the line type to AMI for all 4 E1 or T1 ports.
RESULT: The system selects the line code for all four ports, as in the
following example.
Line code [1/2/3/4] set to [HDB3/B8ZS/AMI]
Enter get line code.
RESULT: The system returns the line code for all four ports, as in the
following example.
Line code [1/2/3/4] set to [HDB3/B8ZS/AMI]
end of procedure
Press Enter.
At the username prompt, enter admin.
At the password prompt, enter password.
Enter set canopy port auto negotiation [on/off]
where
on enables auto negotiation at 100 Mbps Full Duplex (as default).
off forces the port to 100 Mbps Full Duplex without auto negotiation.
RESULT: The system responds
Canopy port auto-negotiation is: on
T1/E1 Multiplexer Release 3.1
Steps
Steps
June 2004
36 of 69
Page