Table of Contents
Advertisement
Omni 3210 Installation Guide
Note: The paper feed slot is located directly above the gray
plastic paper roll cradle, and below the black plastic ridge that
extends slightly from the base of the paper feed mechanism
(refer to Figure 16).
5.
If necessary, hold down the paper feed button until about
five centimeters (two inches) of paper emerge from the
slot below the serrated metal tear strip.
6.
Insert the orange plastic spindle into the hole in the paper
roll you are holding. Then, place the spindle and roll into
the paper roll cradle so the ends of the plastic spindle rest
securely in the two slots.
7.
Replace the paper roll cover by inserting its two front tabs
into the slots on either end of the serrated metal strip and
then lightly pushing down on the back of the cover until it
snaps into place.
(Remember to lift up the end of the paper roll when
replacing the paper roll cover so that the paper rests on top
of the cover.)
Note: The integrated thermal printer has a paper feed release
lever that lets you manually adjust the position of the paper
you have loaded into the printer (refer to Figure 16). To do this,
lift up on the small red lever located on the right side of the
paper roll cradle until it snaps into its "Up" position. You can
now freely move the paper up and down through the feed
mechanism. When the paper is in the correct position, lower
the lever until it snaps back into its "Down" position.
Performing a Power-On Printer Test
When you have installed a paper roll, you can perform a quick
test to make sure the thermal printer is operating correctly:
28
Advertisement
Table of Contents
