Table of Contents
Advertisement
Figure 16 Thermal Printer Features
Installing a Paper Roll
To install a roll of thermal printer paper in the Omni 3210:
1.
Be sure the terminal is connected to a power source. (The
green LED "paper out" light should be blinking off and
on, indicating that the printer needs paper.)
2.
With the terminal on a flat surface and facing toward you,
remove the paper roll cover from the top of the terminal by
lifting up on the back of the cover. The two ridges on each
side of the black plastic cover show you where to grasp it.
3.
Remove the protective strip from a new roll of paper and
cut a clean, straight edge on the leading end of the paper.
4.
Holding the roll in your hand with the paper feeding from
the bottom of the roll, slowly insert the leading end into
the paper feed slot (refer to Figure 16). When the built-in
sensor detects the paper, the feed mechanism engages and
pulls the paper into the printer, ejecting the end of the
paper from the top of the printer over the top of the paper
roll cover.
Omni 3210 Installation Guide
27
Advertisement
Table of Contents
