Table of Contents
Advertisement
Connect a CR 600 Check Reader
Caution: Some peripherals require a separate power source.
Before connecting a CR 600 check reader or similar device, turn
off power to the terminal.
To connect a CR 600 check reader (see Figure 10):
1.
Insert the round mini-DIN type connector on one end of
the serial cable into the TERM. (i.e. Terminal) port on the
back of the check reader.
2.
Insert the RJ45-type connector on the other end of the
serial cable into the RS232 port on the back panel of the
Omni 3210 terminal.
3.
Connect the check reader power pack to a power outlet.
4.
Insert the round barrel-type connector into the power port
on the lower back panel of the check reader.
Figure 10 CR 600 Check Reader Connection
Omni 3210 Installation Guide
19
Advertisement
Table of Contents
