Table of Contents
Advertisement
Omni 3210 Installation Guide
2.
Insert the connector on the other end of the cord into a
nearby RJ-11 type telephone company wall jack. (If you
do not have this type of modular wall jack, you can obtain
an adapter from a local business supply store.)
Set Up a Pass-Through Telephone Line Connection
To set up a pass-through telephone line connection using two
telephone line cords, follow these steps (refer to Figure 9):
1.
Insert the connector on one end of the first
telephone line cord into the Telco port on the
back panel of the terminal. (The Telco port is
identified by the icon shown to the right.)
2.
Insert the connector on the other end of the first telephone
line cable into a nearby RJ-11 type telephone company
wall jack.
3.
Insert the connector on one end of the second
telephone line cable into the Telset port on the
back panel of the terminal. (The Telset port is
identified by the icon shown to the right.)
4.
Insert the connector on the other end of the second
telephone line cable into a RJ-11 type modular jack
located on the back or side of a nearby standard telephone
base unit.
Caution: If you have chosen to use a pass-through connection
for your terminal, do not attempt to make a normal telephone
call while the terminal is processing a transaction. Lifting up the
handset may disrupt the audible data carrier signal and cause the
transaction to fail.
16
Advertisement
Table of Contents
