VeriFone Omni 3210 Installation Manual page 17

Setting Up Telephone Line Connections for Omni
3210 Terminals with Attached Swivel Stand
An optional swivel stand is available
for the Omni 3210 terminal. Many
terminals come with the swivel stand
already attached, as shown to the
right, and with two pre-installed
"pigtail" cables that let you
conveniently connect the power
cable and telephone line cord.
The telephone line pigtail lets you conveniently configure a
direct telephone line connection without removing the swivel
stand. To set up a direct connection using the pigtail cable:
1. Insert the connector on one end of the telephone line cord
into the modular RJ-11 type jack located inside the square-
shaped "female" end of the telephone line pigtail.
2. Insert the connector on the other end of the cord into a
nearby RJ-11 type telephone company wall jack.
To configure a pass-through connection for a terminal with
attached swivel stand, you must remove the stand in order to
properly connect and route the two telephone line cords, and
then re-attach the stand to the terminal.
Note: The procedure for removing and reattaching the swivel
stand is described in the Omni 3XXX Swivel Stand Quick
Installation Guide (VeriFone Part Number 21919).
Omni 3210 Installation Guide
17