Figure 36 - Example Configuration File - Motorola PTP 400 Series User Manual

The configuration file is encoded using an ASCII encoding scheme. An example is show in
Figure 36.
# Motorola PTP 400 Series Configuration file
#
# MAC Address :- 00:04:56:00:20:a2
# IP Address :- 169.254.1.1
# License Key :- 3D3D-92D5-3FD3-1AF1
# Software Version :- 04-00
# Creation Date :- 17-Nov-06 20:03:23
#
# To playback this configuration file into the unit, use the Save and Restore configuration
webpage:
#
<config>+.BP9)7HC;O)DS.UNPAGUTLIHJ:",\K.]"3F6'0*XR14+>) !3-MZ-VF
...
</config>
WARNING: The configuration file is currently restricted to a single software version and can
only be restored into a wireless unit operating the software version indicated in the
configuration file header.
The configuration file can also be used when swapping out a faulty wireless unit. If one of the
wireless units is replaced on a wireless link a configuration file captured from the faulty unit
can be replaced into the new unit to speed up replacement. It should be noted that when
placing a configuration file into a wireless unit with a different MAC Address the license key
will not be restored and may need to be entered. This can be obtained either from the Quick
Install guide supplied with replacement wireless unit or directly from Motorola. Please note
that the target MAC address at the other end will need to change.

Figure 36 - Example Configuration File

84