Wlan Module - HP ProDesk 480 G3 MT Maintenance And Service Manual

WLAN module

WLAN modules can be installed using a PCI expansion card adapter. First install the WLAN module into the
expansion card adapter, and then install the expansion card into the computer.
Description
Broadcom BCM943228Z 802.11n Bluetooth
Broadcom 802.11n, M.2 Bluetooth, Indonesia
Intel 7265 802.11AC Bluetooth
Intel 3165 802.11AC M.2 Bluetooth
To remove the WLAN module:
1. Prepare the computer for disassembly
2. Remove the access panel
3. On the expansion card adapter, disconnect the WLAN antenna cables (1) from the terminals on the
WLAN module.
NOTE:
The WLAN antenna cable labeled "2" connects to the WLAN module "Aux" terminal labeled "2".
4. Remove the Phillips PM2.0×4.0 screw (2) that secures the WLAN module to the computer. (The edge of
the module opposite the slot rises away from the computer.)
5. Remove the WLAN module (3) by pulling the module away from the slot at an angle.
NOTE:
Reverse this procedure to install the WLAN module.
(Access panel on page
The WLAN antenna cable labeled "1" connects to the WLAN module "Main" terminal labeled "1".
WLAN modules are designed with a notch to prevent incorrect insertion.
(Preparation for disassembly on page
24)
23)
WLAN module 47