Card Reader - HP ProDesk 480 G3 MT Maintenance And Service Manual

Card reader

Description
Card reader, USB 3.0
Card reader, USB 2.0
The card reader is attached to the front of the chassis.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. From the outside, front of the chassis, remove the Torx T15 screw that secures the card reader.
5. From the inside of the chassis, disconnect the card reader cable from the system board labeled SD RDR,
and then press the tab on the side of the card reader (1) and slide the card reader out the front of the
chassis (2).
To install the card reader, reverse the removal procedures.
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 25).
24).
23).
Card reader 51