HP ProDesk 480 G3 MT Maintenance And Service Manual page 95

Drive not found (identified).
Cause
The device is attached to a SATA port that has been hidden in
Computer Setup.
Drive responds slowly immediately after power-up.
Nonsystem disk/NTLDR missing message.
Cause
The system is trying to start from the hard drive but the hard
drive may have been damaged.
System files missing or not properly installed.
Hard drive boot has been disabled in Computer Setup.
Bootable hard drive is not attached as first in a multi-hard drive
configuration.
Bootable hard drive is not listed first in the Boot Order.
Computer will not boot from hard drive.
Cause
The device is attached to a SATA port that has been hidden in
Computer Setup.
Boot order is not correct.
Hard drive is damaged.
Solution
Run the Computer Setup utility and ensure Device Available is
selected for the device's SATA port in Advanced > Port Options.
Run Computer Setup and increase the POST Delay in Advanced >
Boot Options.
Solution
▲ Perform Drive Protection System (DPS) testing in system
ROM.
1. Insert bootable media and restart the computer.
2. Boot to the windows installation media and select the
recovery option. If only a restore kit is available, then select
the File Backup Program option, and then restore the
system.
3. Install system files for the appropriate operating system.
Run the Computer Setup utility and enable the hard drive entry in
the Advanced > Boot Options list.
If attempting to boot from a hard drive, ensure it is attached to
the system board dark blue SATA connector.
Run the Computer Setup utility and select Advanced > Boot
Options and ensure the bootable hard drive is listed immediately
under the Hard Drive entry.
Solution
1. Check SATA cable connections.
2. Run the Computer Setup utility and ensure Device Available
is selected for the device's SATA port in Advanced > Port
Options.
Run the Computer Setup utility and change boot sequence in
Advanced > Boot Options.
Observe if the front panel Power LED is blinking RED and if any
beeps are heard. See POST error messages and diagnostic front
panel LEDs and audible codes on page 111
causes for the blinking red and beep codes.
See the Worldwide Limited Warranty for terms and conditions.
Solving hard drive problems
to determine possible
87