Motorola SURFBOARD SVG2500 User Manual page 5

IMPORTANT VOIP SERVICE INFORMATION
When using this VoIP device, you CANNOT make any calls, including an emergency call, and E911
location services WILL NOT be available, under the following circumstances:
•
Your broadband ISP connection goes down, is lost or otherwise fails.
•
You lose electrical power.
When using this VoIP device, you may be able to make an emergency call to an operator, but E911
location services may not be available under the following circumstances:
•
You have changed the physical address of your VoIP device, and you did not update or
otherwise advise your VoIP service provider of this change.
•
You are using a non-U.S. telephone number.
•
There are delays in making your location information available in or through the local automatic
location information database.
Note: Your service provider, not Motorola, is responsible for the provision of VoIP telephony services
through this equipment. Motorola shall not be liable for, and expressly disclaims, any direct or indirect
liabilities, damages, losses, claims, demands, actions, causes of action, risks, or harms arising from or
related to the services provided through this equipment.
FCC STATEMENTS
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential environment. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the device off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the device and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
FCC CAUTION: Any changes or modifications not expressly approved by Motorola for compliance
could void the user's authority to operate the equipment.
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
To comply with the FCC RF exposure compliance requirements, the separation distance between the
antenna and any person's body (including hands, wrists, feet and ankles) must be at least 20 cm (8
inches).
This transmitter must not be co-located or operation in conjunction with any other antenna or
transmitter.
The availability of some specific channels and/or operational frequency bands are country dependent
and are firmware programmed at the factory to match the intended destinations. The firmware setting
is not accessible by the end user.
iv